sponsored links

Community > General Discussion

Topic: My tool isn't ...
Marley Joined Mon 10/02/06 Posts: 3922	Tue 05/24/11 05:18 PM
...working properly. Incorrect dynamic...poor penetration. Perhaps a thorough lubrication. I dunno. Would like to see it function according to specs by tomorrow. My job requires it.

Mayhem_J Joined Mon 07/21/08 Posts: 14265	Tue 05/24/11 05:22 PM
Take the little blue pill....

red_lace Joined Sat 04/17/10 Posts: 7247	Tue 05/24/11 05:22 PM
So basically, your tool is attached to another object by an inclined plane, wrapped helically around an axis. You know, screwed.

misty_57 Joined Sat 12/01/07 Posts: 1618	Tue 05/24/11 05:24 PM
Well good luck with that

motowndowntown Joined Wed 11/19/08 Posts: 21484	Tue 05/24/11 05:28 PM
Maybe you need to readjust your ball bearings.

Tribbles Joined Tue 11/17/09 Posts: 7349	Tue 05/24/11 05:31 PM
Alright, riddle me this... do you think it needs an Ænima?

soufiehere Joined Sat 10/24/09 Posts: 45350	Tue 05/24/11 05:45 PM
...working properly. Incorrect dynamic... poor penetration. Perhaps a thorough lubrication. I dunno. Would like to see it function according to specs by tomorrow. My job requires it. Maybe if you shared the specs..

delilady Joined Fri 07/24/09 Posts: 23825	Tue 05/24/11 05:47 PM
Maybe it could benefit from a blow torch

josie68 Joined Mon 11/22/10 Posts: 6270	Tue 05/24/11 06:20 PM
...working properly. Incorrect dynamic... poor penetration. Perhaps a thorough lubrication. I dunno. Would like to see it function according to specs by tomorrow. My job requires it. Maybe if you shared the specs.. Hmmm perhaps if you showed us we could give you a few more instructions

Community > General Discussion